Due to a technical problem, our website is only available to a limited extent. This also affects our download service area. We are already working on the solution and ask for your understanding.
Dual-function display electronic
Codix 54P
|
|
Position display with separate tachometer, scalable.
The Codix 54P is a voltage-powered pulse counter/ position display with 4 different count input modes and separate tachometer. With separate inputs, for fast and slow count pulses, with 6-digit LED display for NPN, PNP input signals.| Mechanical | |
|---|---|
| Model | Dual-function device electronic |
| Functions |
Pulse counter Frequency display Position displays without limit values Tachometer without limi valuets Dual-function display |
| Dimension 1 |
96 x 48 mm | 92 x 45 mm |
| Protection level |
IP65 |
| Working temperature | -20 °C ... +65 °C |
| Weight | 150 g |
| Reset |
electronic |
(1) Front panel size | Panel cut-out
| Electrical | |
|---|---|
| Power supply |
100...240 (± 10%) V AC 10...30 V DC |
| Signal input |
NPN PNP |
Powerful
- Fast count and frequency input – input frequency max. 30 kHz
- Robust housing – IP65 protected
- Very bright LED display, 14 mm high, 6 digits
- Very accurate precise frequency measurement principle (HRA-High Rate Accuracy System) Frequencies up to 38 Hz are calculated using time-interval (period duration) measurement. Frequencies > 38 Hz are calculated using a special time base (gate time) measurement. A very high accuracy of < 0.1% is achieved, even with very short gate times. The resulting measurement is available after a max. of 50 ms.
- Short start-up time – detects input pulses just 16 msec after being switched on => no pulses are lost with a simultaneous motor start-up
- Large keys – can also be operated when wearing gloves
- Programming:
- Simple uniform menu-driven programming and operation
- Possible to enter the programming also during operation with a confirmation prompt
- Pressing the right key switches between displays
- Individually programmable scaling: multiplication and division factor (0.0001…99.9999), to display corresponding engineering units, e.g. position in 1/10 mm and speed in RPM
- Separate factors for frequency and pulse counting
- 4 different count input modes for the position display: 2-channel input for detecting count direction, difference or adding mode, quadrature x1, x2 or x4. 1 separate input for rotary speed and speed, display in 1/min or 1/sec
- AC or DC supply with sensor power supply
- Inputs: as an alternative to the HTL inputs, devices with a 5 V DC input level are available, for use as parallel displays for PLCs
